|September 19, 2011, 09:40||
initial solution for a two phase simulation
Join Date: Sep 2011
Posts: 48Rep Power: 7
Thanks for your help.
I want to use the tool swak4Foam to set the velocity and volume fraction in the cell zones of a domain.
I have went through the wiki page of this tool.
There are many thing I don not understand.
Is the tool already include in OF 2.01. or do I need to install it?
If I need to install it myself how do I do exactly?
I just want to set a the exact value for the volume fraction in one zone of my mesh? How can I do?
I have the field for velocity for one region of my mesh. How can I set it with swak4Foam?
Thanks for your help. I am a bit confuse. I can't find clear instructions in the forum on the various topics treating this question.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Extrusion with OpenFoam problem No. Iterations 0||Lord Kelvin||OpenFOAM Running, Solving & CFD||8||March 28, 2016 11:08|
|transsonic nozzle with rhoSimpleFoam||Unseen||OpenFOAM Running, Solving & CFD||7||April 16, 2014 03:38|
|Orifice Plate with a fully developed flow - Problems with convergence||jonmec||OpenFOAM Running, Solving & CFD||3||July 28, 2011 05:24|
|Full pipe 3D using icoFoam||cyberbrain||OpenFOAM||4||March 16, 2011 10:20|
|Unknown error||sivakumar||OpenFOAM Pre-Processing||9||September 9, 2008 12:53|