|October 16, 2011, 03:57||
How to set different zone in OpenFOAM?
Join Date: Jul 2011
Posts: 13Rep Power: 7
I want to simulate flow of flapping airfoil using dynamic mesh. The computational grid is like this: surrounding the airfoil is structured grid and all the points moving in the same velocity as the airfoil;Out of the Structured grid is unstructured grid and outer boundary of the unstructured grid is static. I have known how to generate such grid but I do not know how to set the case in OpenFOAM(i.e. how to divide the mesh into different zones and set different mesh motion solvers respectively). So does anybody know and tell me? Thanks very much!
|October 16, 2011, 04:45||
Join Date: Mar 2009
Location: Lisbon, Portugal
Blog Entries: 39Rep Power: 106
I wrote something about this a few minutes ago. You can read the following two posts:
|Thread||Thread Starter||Forum||Replies||Last Post|
|2D Mesh Generation Tutorial for GMSH||aeroslacker||Open Source Meshers: Gmsh, Netgen, CGNS, ...||12||January 19, 2012 04:52|
|cgnsToFoam problems with "QUAD_4" cells||lentschi||OpenFOAM Meshing & Mesh Conversion||1||March 9, 2011 05:49|
|set zone in interDyMFoam (OF1.5-dev). how to?||DLC||Main CFD Forum||0||November 25, 2009 11:53|
|The OpenFOAM extensions project||mbeaudoin||OpenFOAM||16||October 9, 2007 09:33|
|Fluent incident radiation problem||Michael Schwarz||Main CFD Forum||0||October 21, 1999 05:56|