About the 1st Example and Paraview

hahajiushixing · January 11, 2012, 16:34

Hi,
I am doing the 1st example of the tutorial: the incompressible cavity flow. I had typied:

mkdir -p $FOAM_RUN
cp -r $FOAM_TUTORIALS $FOAM_RUN
cd $FOAM_RUN/tutorials/incompressible/icoFoam/cavity
blockMesh

And next, after I typed:

paraFoam

The terminal showed:

OpenGL Warning: No pincher, please call crStateSetCurrentPointers() in your SPU
OpenGL Warning: No pincher, please call crStateSetCurrentPointers() in your SPU

And the paraview started with nothing having been done...I don't know why as well as what I should do. Actually I am a new Linux User and Foamer.
Appreciate it if there is any help!
Best,
Hahajiushixing

anon_a · January 11, 2012, 17:55

Did you run the icoFoam solver?
It is not mentioned in your steps (but it is in the tutorial)

hahajiushixing · January 13, 2012, 00:32

Thank you for your reminding, anon_a! I works!
Best,
Nan Si

January 11, 2012, 16:34	About the 1st Example and Paraview	#1
hahajiushixing New Member Nan Si Join Date: Jan 2012 Posts: 9 Rep Power: 15	Hi, I am doing the 1st example of the tutorial: the incompressible cavity flow. I had typied: mkdir -p $FOAM_RUN cp -r $FOAM_TUTORIALS $FOAM_RUN cd $FOAM_RUN/tutorials/incompressible/icoFoam/cavity blockMesh And next, after I typed: paraFoam The terminal showed: OpenGL Warning: No pincher, please call crStateSetCurrentPointers() in your SPU OpenGL Warning: No pincher, please call crStateSetCurrentPointers() in your SPU And the paraview started with nothing having been done...I don't know why as well as what I should do. Actually I am a new Linux User and Foamer. Appreciate it if there is any help! Best, Hahajiushixing

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

January 11, 2012, 17:55		#2
anon_a Disabled Join Date: Mar 2011 Posts: 174 Rep Power: 16	Did you run the icoFoam solver? It is not mentioned in your steps (but it is in the tutorial)

January 13, 2012, 00:32		#3
hahajiushixing New Member Nan Si Join Date: Jan 2012 Posts: 9 Rep Power: 15	Thank you for your reminding, anon_a! I works! Best, Nan Si