DirectMapped, ChannelFoam

libra · February 23, 2012, 01:59

Hi everyone
I am simulating the water flow in a pipe using openFOAM 1.6. I use LES, channelFoam and directmapped. When running the case I get the following error:

--> FOAM FATAL ERROR:
Did not find sample (0.0144554 0.00104187 0.45) on any processor of regionregion0

Does anyone know what the problem is?

timo_IHS · February 23, 2012, 02:17

I think it is a bug.
It should be fixed in 1.7

libra · February 23, 2012, 21:24

Thanks for your comment.
The problem was that I had missed this fact that offset is a vector and the direction of it is from the patch(in my case inlet patch) to the offset plane.

February 23, 2012, 01:59	DirectMapped, ChannelFoam	#1
libra New Member Melika Join Date: Feb 2012 Location: Japan Posts: 24 Rep Power: 14	Hi everyone I am simulating the water flow in a pipe using openFOAM 1.6. I use LES, channelFoam and directmapped. When running the case I get the following error: --> FOAM FATAL ERROR: Did not find sample (0.0144554 0.00104187 0.45) on any processor of regionregion0 Does anyone know what the problem is?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
perturbation in channelFoam?	cheng1988sjtu	OpenFOAM Running, Solving & CFD	5	November 2, 2011 15:36
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
new direct mapped programming bc directmapped	Thomas Baumann	OpenFOAM	9	June 15, 2011 09:11
new directMapped BC for the gradient	David_010	OpenFOAM	0	October 14, 2010 06:29
directMapped boundary conditions : pitzDaily3D testcase	And	OpenFOAM	0	September 9, 2010 05:11

February 23, 2012, 02:17		#2
timo_IHS Member Timo K. Join Date: Feb 2010 Location: University of Stuttgart Posts: 66 Rep Power: 16	I think it is a bug. It should be fixed in 1.7

February 23, 2012, 21:24		#3
libra New Member Melika Join Date: Feb 2012 Location: Japan Posts: 24 Rep Power: 14	Thanks for your comment. The problem was that I had missed this fact that offset is a vector and the direction of it is from the patch(in my case inlet patch) to the offset plane.