|September 27, 2012, 08:01||
Make streamlines from Fluent data
Gian Maria Di Stefano
Join Date: Jan 2011
Location: University of Applied Science Manno (CH)
Posts: 10Rep Power: 8
I need help, please.
I have done some simulations with Ansys Fluent with my case. Now, I want to visualize results with Paraview 3.14.1 .
First of all, I have exported simulation results from Fluent to Encase Gold case, generating some files such as
To import results in Paraview I have changed the name of the first file, from
And it works! Now I'm viewing my results in Paraview.
Then, I click on "filter -> extract block" and I've extract all the wall to visualize my geometry.
Now, my problem. I want to create streamlines, but, how can I do this?
If I use OpenFoam data I can use "filter -> stream tracer with custom source", and than, select
- input -> simulation results
- source -> inlets
But, if I try to do the same with Fluent data, I can not select anything in "source"
I think I need to extract inlet surfaces to assign them to "source" of the streamlines.
Thank you in advance
Gian Maria Di Stefano - Thermodynamic assistant at SUPSI (CH)
|Thread||Thread Starter||Forum||Replies||Last Post|
|fluent udf, saving data in udf||mohsen zendehbad||Fluent UDF and Scheme Programming||14||August 3, 2016 07:23|
|fluentMeshToFoam multidomain mesh conversion problem||Attesz||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||12||May 2, 2013 10:52|
|how to obtain time averaged data in Fluent when using SM to simulate mixing tank||ziyan7||FLUENT||4||February 14, 2012 03:08|
|fluent 13 export solution data||Zyryx||FLUENT||1||November 11, 2011 11:09|
|data output from batch fluent run||Wang||FLUENT||4||March 11, 2005 12:01|