[OpenFOAM] Paraview reads magU but paraFoam does not!

amuzeshi · December 31, 2019, 08:44

Hello there
I have modified scalarTransportFoam in order to also write velocity magnitude (named magU) in time directories.
By paraFoam, magU is not selectable in coloring menu(fig 1), while it is accessible when using paraview (fig 2) It is worth noting that in both cases, magU is selected in fields (fig 3)

amuzeshi · January 2, 2020, 05:44

Solved!
The problem was that when prompting paraFoam, it starts from "0" where no magU is written into.
On the other hand, when prompting paraview, it starts from the directory right after "0" where magU is written into.
Therefore, magU is also selectable in paraFoam for all times but not "0".

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.com] paraFoam cannot open due to Qt issues - [Solved/Information]	u2berggeist	OpenFOAM Installation	2	July 2, 2018 17:03
Parafoam - FATAL ERROR: ParaView reader module libraries do not exist	Amit_Pawarpawar	OpenFOAM Installation	1	August 25, 2014 10:31
[OpenFOAM] run paraFoam command results in error: line 267: paraview: command not found.	Asik	ParaView	1	December 25, 2013 11:45
[OpenFOAM] parafoam - paraview help function	felik9	ParaView	5	June 3, 2010 15:03
[OpenFOAM] Segmentation fault with paraFoam and paraview 3.6.1 on Fedora 11 32 and 64 bit	nanes	ParaView	2	September 11, 2009 09:12

January 2, 2020, 05:44		#2
amuzeshi Senior Member Ali Shayegh Join Date: Oct 2015 Posts: 130 Rep Power: 10	Solved! The problem was that when prompting paraFoam, it starts from "0" where no magU is written into. On the other hand, when prompting paraview, it starts from the directory right after "0" where magU is written into. Therefore, magU is also selectable in paraFoam for all times but not "0".