 |
 |
 |
|
|
|
[Sponsors] | ||||
April 10, 2013, 18:23
|
Center of Mass
|
#1 |
|
New Member
Thomas
Join Date: Aug 2011
Posts: 11
Rep Power: 15  |
Hello.
I have a 2D contour plot and I like to calculate the center of mass. How I can do that in Paraview? Is it equivilant with "Integrate Variable". Thanks. Regards Last edited by test3r; April 10, 2013 at 18:48. |
|
|
|
|
 |
| Tags |
| center of mass |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Center of Mass of Two-Phase Flow | JoshuaSmith | FLUENT | 1 | October 2, 2018 13:49 |
| Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
| Calculating center of mass | kristaps | OpenFOAM Running, Solving & CFD | 2 | March 8, 2015 04:59 |
| total mass loss/gain--simulating taylor couette flow | nwpukaka | OpenFOAM Programming & Development | 0 | February 12, 2014 18:57 |
| Problem setting with chtmultiregionFoam | Antonin | OpenFOAM | 10 | April 24, 2012 09:50 |
Linear Mode
