Problem showing flow around propeller in Paraview
1 Attachment(s)
I am working on a problem of my own which was adapted from the propeller case in Pimpledymfoam. I am a novice with PF so I am not really familiar on how to get things to show up. I have run the case and now I would like to see my results in paraview. How do I obtain images of the flow around my propeller (like the one seen in the example picture below)? I have tried everything without any luck.
|
Greetings orkavic,
First, one very important question: did you follow with success the tutorials on the OpenFOAM User Guide? Namely the ones shown here: http://www.openfoam.org/docs/user/tutorials.php Second question: the attached image seems to be showing a section-cut, with the representation of the magnitude of U. This can be done with the Slice filter and then by choosing the U field and magnitude. To have a better perception, search for the Figure 2.4 in this page: http://www.openfoam.org/docs/user/cavity.php Best regards, Bruno |
All times are GMT -4. The time now is 07:05. |