How can I compute the area of recirculation zone in pitzDaily
1 Attachment(s)
Hello,
I would like to compute the area of recirculation zone from the streamline pattern shown in the attached figure. Is it possible to compute the area of the recirculation zone in Paraview according to the outer streamline of the recirculation zone? Best regards, Ender |
Hi Ender,
Did you find a way to do this? I am trying to calculate the volume of three different recirculation zones inside a tank but have had no luck so far. Declan |
All times are GMT -4. The time now is 10:02. |