 |
 |
 |
|
|
|
[Sponsors] | ||||
February 15, 2016, 03:58
|
Export surface to CGNS
|
#1 |
|
New Member
anonymous
Join Date: Dec 2015
Posts: 2
Rep Power: 0  |
Hello,
I have a free surface calculation around an object. The volume solution is a .vtu file. I extract a surface which is my object and a second which is my free surface. I would like to save these two surfaces in one single CGNS file. The reason is that I would like to do the rendering in another licensed software. Could you please help me with this and tell me if there is a direct/indirect way to do this ? Thanks in advance I. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pointwise export to CGNS | Turbulent | Pointwise & Gridgen | 3 | September 5, 2018 11:31 |
| [General] Creating surface based on XYZ input and display data fron CGNS | MarkHerskind | ParaView | 0 | October 23, 2014 09:07 |
| Unable to install OpenFOAM 1.6-ext | Maimouna | OpenFOAM Installation | 23 | May 8, 2014 05:47 |
| How to export cgns file from res file with only some variables? | zeitistgeld | CFX | 0 | July 14, 2010 13:59 |
| CCM+ Surface Wrapper Export | Ross Kippenbrock | Siemens | 2 | July 29, 2008 14:27 |
Linear Mode
