 |
 |
 |
|
|
|
[Sponsors] | ||||
October 12, 2016, 10:17
|
plot over time
|
#1 |
|
New Member
Sara Zahedinezhad
Join Date: Oct 2016
Posts: 1
Rep Power: 0  |
Hello everyone ,
I had a question regarding paraview .I'm beginner in Paraview . I'm using the lastest version of paraview and I want to plot velocity over time..velocity is defined in cell form not points. I tried to use selection Inspector but I couldn't get any results.nothing jus two axis . so it would be great if you could help me . Regards, Sara |
|
|
|
|
|
October 28, 2016, 10:30
|
|
#2 | |
|
New Member
Konstantin
Join Date: Jun 2015
Posts: 8
Rep Power: 11 |
Quote:
You need to select the cell, after then apply for selection "Plot Selection Over Time" filter. Wait a few second or minutes and "Tada!!" 
|
||
|
|
|
||
 |
| Tags |
| paraview, paraview 5.1.2, plot vs time |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Elastic or Plastic Deformations in OpenFOAM | NickolasPl | OpenFOAM Pre-Processing | 36 | September 23, 2023 08:22 |
| pressure in incompressible solvers e.g. simpleFoam | chrizzl | OpenFOAM Running, Solving & CFD | 13 | March 28, 2017 05:49 |
| Micro Scale Pore, icoFoam | gooya_kabir | OpenFOAM Running, Solving & CFD | 2 | November 2, 2013 13:58 |
| mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
Linear Mode
