|
[Sponsors] |
[OpenFOAM] Stream tracers not working properly in paraview |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2023, 09:59 |
Stream tracers not working properly in paraview
|
#1 |
New Member
Daniel
Join Date: Sep 2023
Posts: 5
Rep Power: 2 |
Trying to get some stream tracers on an Ahmed body simulation, but I cannot get them to go all the way over the body. Any ideas on why this is? See attached screenshot below for my issue
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
udf not working properly | Ravi palla | Fluent UDF and Scheme Programming | 1 | June 19, 2022 09:24 |
[OpenFOAM.com] "I/O: uncollated" and Paraview Not Working | User100000 | OpenFOAM Installation | 5 | April 4, 2022 23:09 |
[mesh manipulation] stitchMesh Not Working Properly | leuthar | OpenFOAM Meshing & Mesh Conversion | 2 | November 30, 2020 07:30 |
[OpenFOAM] Stream tracers problem | tsencic | ParaView | 34 | June 8, 2015 09:37 |
[OpenFOAM] ParaView 3.6.1 3D viewer not working | will_avoid_comm_solvers | ParaView | 2 | March 9, 2010 16:13 |