 |
 |
 |
|
|
|
[Sponsors] | ||||
[General] Slice normal to a custom polynomial |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 15, 2016, 16:51
|
Slice normal to a custom polynomial
|
#1 |
|
Member
Ali
Join Date: Aug 2011
Location: Milwaukee
Posts: 34
Rep Power: 14  |
Hello everyone,
I have a question that probably has a very simple answer but I wasnt able to find it any where. I have a complex geometry that I have the center line for it. Now I want to slice different sections normal to the center line. Is it possible to do it with the slice filter? If yes, how? Thanks for your time Ali |
|
|
|
|
|
November 16, 2016, 14:37
|
Problem solved
|
#2 |
|
Member
Ali
Join Date: Aug 2011
Location: Milwaukee
Posts: 34
Rep Power: 14 |
I found vmtk which does a great job for my case.
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Wedge patch '*' is not planar | LilumDaru | OpenFOAM Meshing & Mesh Conversion | 6 | January 12, 2021 05:55 |
| [snappyHexMesh] snappyHexMesh error "Cannot determine normal vector from patches." | lethu | OpenFOAM Meshing & Mesh Conversion | 1 | June 3, 2020 07:49 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 09:53 |
| [CAD formats] my stl surface is seen as just a line | rcastilla | OpenFOAM Meshing & Mesh Conversion | 2 | January 6, 2010 01:30 |
| NACA0012 geometry/design software needed | Franny | Main CFD Forum | 13 | July 7, 2007 15:57 |
Linear Mode
