CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ParaView

How to isolate geometric elements in a solution file?

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   January 17, 2017, 11:14
Default How to isolate geometric elements in a solution file?
  #1
New Member
 
Michael
Join Date: Jul 2016
Location: Auburn, Alabama
Posts: 8
Rep Power: 2
Jasfss is on a distinguished road
So, essentially, I've got my solution I'm reading into paraview but it consists of a rectangular cylinder enclosing an airfoil section; an airfoil in a water tunnel setup. I'd like to only view the solution about the airfoil since this is the geometry of interest, and I know that the walls of the tunnel, the inlet, the outlet, and the airfoil section itself are all listed as separate entities, but I'm not sure how to actually isolate the airfoil within paraview.

Thanks for any help/tips you can offer.
Jasfss is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
polynomial BC srv537 OpenFOAM Pre-Processing 4 December 3, 2016 10:07
problem when installing foam-extend-1.6 Thomas pan OpenFOAM Installation 7 September 9, 2015 21:53
Problem installing swak_2.x for OpenFoam-2.4.0 towanda OpenFOAM Installation 6 September 5, 2015 21:03
Swak4FOAM 0.2.3 / OF2.2.x installation error FerdiFuchs OpenFOAM Installation 27 April 16, 2014 15:14
DxFoam reader update hjasak OpenFOAM Post-Processing 69 April 24, 2008 01:24


All times are GMT -4. The time now is 03:49.