|March 21, 2017, 07:11||
speed up ParaView on workstation
Join Date: Jun 2016
Posts: 2Rep Power: 0
I have a general ParaView question.
My PC is a workstation with 30 cores and 198GB of RAM.
Is there a way to take advantage of this to speed up ParaView? For example, a PlotSelectionOverTime is now taking about 10 minutes for my data (with 250 saved times steps). And after that, playing the PlotSelectionOverTime takes around 30 minutes. My data are in the format of .vtk.
Under Edit<Settings<General, I have already activated multi-core support. But, this has limited impact.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pre- and Post workstation - need inputs||larsenmm||Hardware||17||February 13, 2013 05:16|
|Paraview launch & crash problems||dancfd||ParaView||3||January 17, 2013 13:04|
|Visualize checkMesh output with Paraview||Horus||OpenFOAM||1||May 29, 2012 11:51|
|paraFoam reader for OpenFOAM 1.6||smart||OpenFOAM Installation||13||November 16, 2009 22:41|
|PC vs. Workstation||Tim Franke||Main CFD Forum||5||September 29, 1999 15:01|