Different Initial values in Paraview
Hello guys,
I am performing an external unsteady flow using pisoFoam. I set k, omega for the internal mesh and inlet, however when I see these values in paraview it doesn't match. Example: k is zero in the mesh and 3 on the inlet, and I did set k as 3.78e-9 for inlet and internal mesh. Omega is zero in inlet and internal mesh, and I did set as 0.3765. Could someone explain why is it happening? Thanks a lot. |
I used the command paraFoam & instead open from paraview.. It worked!
|
All times are GMT -4. The time now is 20:16. |