 |
 |
 |
|
|
|
[Sponsors] | ||||
December 6, 2017, 09:37
|
Paraview: wrong pressure field
|
#1 |
|
New Member
Emanuele De Stradis
Join Date: Nov 2017
Posts: 14
Rep Power: 8  |
Hi everyone,
I'm trying to simulate the impact of an hull on the water. Everything was going well until today. The results were as I expected. Today I've ran the simulation in parallel and after view the results in paraview. But the results were different! (I don't have the old simulation images, but the figure below shows the pressure field at timestep 0.2 s for this simulation. It seems that the pressure is too high but the hull hasn't hit the water yet!). Is it possible? This is too strange, I can't figure it out. I need your help, thank you so much. Emanuele |
|
|
|
|
|
December 7, 2017, 09:49
|
|
#2 |
|
New Member
Emanuele De Stradis
Join Date: Nov 2017
Posts: 14
Rep Power: 8 |
Hi guys,
I solved the problem. It was just a matter of scale. Thank you anyway. Emanuele |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
| Residuals and forces spiraling out of control before failing | edomalley1 | OpenFOAM Running, Solving & CFD | 3 | September 7, 2018 10:42 |
| sonicFoam - pressure driven pipe: flow continuity violation and waveTransmissive BC | Endel | OpenFOAM Running, Solving & CFD | 3 | September 11, 2014 16:29 |
| tank sloshing - getting wrong pressure | enghamed | CFX | 2 | April 26, 2011 22:09 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |
Linear Mode
