 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2018, 03:24
|
Mass Flow - Plot over Time
|
#1 |
|
New Member
FW
Join Date: Mar 2018
Posts: 9
Rep Power: 9  |
Hello everybody,
i'am trying to monitor the mass flow through a boundary (the inlet and outlet patch). The steps i made are the following: -Extract a new block (inlet and outlet separately) -Filter on each of them: -Calculator (Attribute Mode: to Cell Data; Result Name Array: inflow/outflow, Calculation: U_Y*rho (For me, y is the orientation of the pipe)) -Integrate Variables -Opening a new Layout and choose RenderView to visualize the Integrate Variables (one small point) -Select Cells though and choosing the point -Applying the PlotSelectionOverTime Now i cant find the inflow/outlow in the quartile Chart. Any suggestions? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure Outlet Targeted Mass Flow Rate | LuckyTran | FLUENT | 1 | November 23, 2016 11:40 |
| Periodic channel flow with time dependent mass flow rate | QBeast | FLUENT | 3 | May 10, 2013 14:14 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
Linear Mode
