 |
 |
 |
|
|
|
[Sponsors] | ||||
November 14, 2019, 07:51
|
How to remove part of a plane
|
#1 |
|
New Member
Join Date: Nov 2019
Posts: 1
Rep Power: 0  |
Hi everyone.
I have this image of resistivity data and a plane containing the topographic data and aerial photo overlain on top. Unfortunately, there is interference between the resistivity data and the plane. Is there a way of cutting out the section of a plane in which the resistivity data is located, so that the interference goes? |
|
|
|
|
|
February 3, 2020, 15:55
|
|
#2 |
|
Member
Join Date: Nov 2015
Posts: 38
Rep Power: 12 |
A quick fix may be to use a "Transform" filter to move the plane with imagery down in the z-direction a negligible amount to "separate" the data sets.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Combine part surfaces if along a specified plane | miragemobile | STAR-CCM+ | 1 | March 26, 2019 19:43 |
| Using a variable to set a plane | wjbvg5 | EnSight | 1 | September 1, 2017 17:51 |
| Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 10:16 |
| Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 18:08 |
Linear Mode
