|
[Sponsors] |
[OpenFOAM] Normalize Glyph Arrows and line source frozen. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2020, 15:33 |
Normalize Glyph Arrows and line source frozen.
|
#1 |
Member
Join Date: Feb 2013
Posts: 60
Rep Power: 13 |
Hello,
1. I am trying to switch over from CFD-Post. One thing that is very easy to do in Post is to normalize the arrows in a gradient plot so that they are all the same size. But I cannot figure out how to do this in Paraview. How can it be done? Here is my setup: 2. When plotting a streamline, I am using the High Resolution Line Source and it sets a line across the figure. I was able to move the line just fine up until it suddenly was not moveable. A little cross-hair shows up when I hover the mouse over one end, but the ball doesn't turn green and I can't grab the line anywhere. Why?? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The CoP Does not exist: Validating Aerodynamic forces through a "line of action" | ds4719 | Main CFD Forum | 14 | February 18, 2022 18:05 |