CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Visualization & Post-Processing Software > ParaView

[General] How to convert DEM point data to cell data form?

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   June 26, 2020, 18:07
Default How to convert DEM point data to cell data form?
  #1
New Member
 
Mohamed Sobhi
Join Date: Sep 2017
Posts: 4
Rep Power: 4
Moha Sobhi is on a distinguished road
Hello everyone!

I have a DEM case that contains two solid particles and I would like to have the results in cell data form (e.g., void fraction, velocity, …etc) instead of the default DEM output (point data “Diameter, Velocity”).

I tried using ParaView filter “point to cell data”, but it didn’t work. Maybe, I did something no correct, because I am not expert in the Paraview.

I appreciate it if somebody can give me good directions!

Mohamed
Moha Sobhi is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[General] what is difference between point data and cell data? kyurinPark ParaView 1 June 19, 2018 18:49
CFD by anderson, chp 10.... supersonic flow over flat plate varunjain89 Main CFD Forum 18 May 11, 2018 07:31
[blockMesh] error EOF in blockMesh Ahmed Khattab OpenFOAM Meshing & Mesh Conversion 7 May 17, 2012 00:37
Cells with t below lower limit Purushothama Siemens 2 May 31, 2010 21:58
CFX4.3 -build analysis form Chie Min CFX 5 July 12, 2001 23:19


All times are GMT -4. The time now is 08:49.