[General] Export results from fluent to paraview

Danny_cfd · August 4, 2021, 04:00

Hello every one,Good morning.

I am currently using fluent to do some simulations and i am also using open foam for the same project. I want to use single post processor paraview in the both cases. For open foam every thing goes well with paraview. However, this is not the case with the fluent to paraview export.

I used the same method as the people described in this forum already. My case is 2D-Steady state case and i want to export 2d temperature profile to paraview.In fluent, I select ensight gold ascii format in solution export although i do not have license for ensight gold, just have fluent.

After that I changed the .encas to .case format and open it in the paraview. However, I get the following error:

Capture1.JPG

Dear seniors, please suggest me the solution for this problem. I am extremely thankful for your review and response.

GOOD DAY.
danny

John_P · October 29, 2021, 00:59

Hi, there appears to be two different slash directions in the file path.

Is one system linux, the other windows perhaps?

tsevine · November 20, 2021, 14:21

hey, I would use binary format first. If you get error again, you can try CGNS format.

August 4, 2021, 04:00	Export results from fluent to paraview	#1
Danny_cfd New Member Join Date: Jan 2021 Posts: 14 Rep Power: 5	Hello every one,Good morning. I am currently using fluent to do some simulations and i am also using open foam for the same project. I want to use single post processor paraview in the both cases. For open foam every thing goes well with paraview. However, this is not the case with the fluent to paraview export. I used the same method as the people described in this forum already. My case is 2D-Steady state case and i want to export 2d temperature profile to paraview.In fluent, I select ensight gold ascii format in solution export although i do not have license for ensight gold, just have fluent. After that I changed the .encas to .case format and open it in the paraview. However, I get the following error: Capture1.JPG Dear seniors, please suggest me the solution for this problem. I am extremely thankful for your review and response. GOOD DAY. danny

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
looking for a smart interface matlab fluent	chary	FLUENT	24	June 18, 2021 09:07
Inconsistency in Fluent results with calculation	Abhinand	FLUENT	3	February 5, 2020 03:43
[foam-extend.org] foam-extend-4.0 gcc errors & maybe paraFoam	powerline332	OpenFOAM Installation	3	May 24, 2018 21:16
[General] Animating unsteady data from Fluent in Paraview..	frodooon	ParaView	10	May 9, 2014 10:39
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41

October 29, 2021, 00:59		#2
John_P New Member John Pitman Join Date: Jan 2020 Posts: 6 Rep Power: 6	Hi, there appears to be two different slash directions in the file path. Is one system linux, the other windows perhaps?

November 20, 2021, 14:21		#3
tsevine New Member Tansu Join Date: Apr 2014 Location: Turkey Posts: 16 Rep Power: 11	hey, I would use binary format first. If you get error again, you can try CGNS format.