 |
 |
 |
|
|
|
[Sponsors] | ||||
May 8, 2022, 07:42
|
Integrate variables over a line
|
#1 |
|
Member
Join Date: Jun 2020
Posts: 49
Rep Power: 7  |
Hello everyone,
i need some advice regarding the IntegrateVariables filter. I want to integrate variables from an OpenFOAM CFD-Simulation along a line. To do this i did the following: - create two orthogonal slices which intersect at the line I want to integrate - apply the IntegrateVariables filter on the second slice, that creates the line However, the integrateVariables filter seems to not identify the line as a set of multiple data points. The information tab on the filter shows a range of 0 in all three dimensions and the output values make no sense at all. I would greatly appreciate, if someone could give me some input on possible mistakes I am making. Thanks in advance! |
|
|
|
|
 |
| Tags |
| integrate variables |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues With Exporting From GMSH | rberdon | Mesh Generation & Pre-Processing | 0 | February 11, 2021 12:11 |
| problem during mpi in server: expected Scalar, found on line 0 the word 'nan' | muth | OpenFOAM Running, Solving & CFD | 3 | August 27, 2018 05:18 |
| Derivative of velocity and mean velocity | hiuluom | OpenFOAM Post-Processing | 1 | May 30, 2015 00:42 |
| [OpenFOAM] could not open file .vtk in paraview | ali_atrian | ParaView | 8 | August 27, 2014 11:31 |
| Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 15, 2003 00:19 |
Linear Mode
