Home > Forums > Visualization & Post-Processing Software > ParaView

[General] Exporting Exodus database file with sidesets

Mark Forums Read

Reply

Search this Thread

June 29, 2024, 04:42	Exporting Exodus database file with sidesets	#1
mahdialloush New Member Mhamad Mahdi Alloush Join Date: Sep 2015 Location: Beirut, Lebanon Posts: 11 Rep Power: 12	Hi, I imported an openfoam mesh into paraview and I need to export it to as an exodus database file with sidesets. Actually, I tried doing this but the boundaries of the mesh do not show up in the exodus file as sidesets, but rather element blocks. Is there any way I can ensure the boundaries to appear as sidesets in the exodus file?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 09:46
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 04:30
polynomial BC	srv537	OpenFOAM Pre-Processing	4	December 3, 2016 10:07
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0	towanda	OpenFOAM Community Contributions	6	September 5, 2015 22:03
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 02:41

All times are GMT -4. The time now is 00:02.