 |
 |
 |
|
|
|
[Sponsors] | ||||
[OpenFOAM] Output data file on the line of the example |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 13, 2008, 04:59
|
Output data file on the line of the example
|
#1 |
|
Senior Member
ZHOU Bin
Join Date: Mar 2009
Location: Nanjing/Torino, Nanjing/Piemente, China/Italy
Posts: 164
Rep Power: 16     |
As we know, we could get the data file after we set the 'writeinterval', i.e. 0.1, 0.2...data directory.
Now when I open the U file in 0.5 directory, I could see that they are (ux, uy,uz) in 'internalField', but I do not know where is the position of these velocity data? By the way, after I practice 2.1.5.7 plotting graphs, I want to output the data in this line, so that I could use other software (e.g. Excel) to deal with these data, but I do not know how to output? Thank you for your attention for the above two questions. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
| [swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
| Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Linear Mode
