ParaView Illustration
Hi,
I'm a french student in a german company. I'm alone in my company to use OpenFoam. I have OpanFOAM 1.6 and 1.5 but now I try just of the 1.6 version. From a ProEngeener-files, I generate a tetrahedral mesh with StarCCM+, then I convert this mesh in .ccm with the same software. Thank to the ccm26ToFoam command, I convert the .cmm-file. After that or after the calculation, I start paraView to see my part but I see just a square (in 2d like a pattern but it's not the cylinder), whereas i should see a cylinder. The illustration works on OF 1.5 but doesn't work on the 1.6. With a part in a parallepiped geometry, it works always (OF 1.5 and 1.6). What is my problem ? Thank you Simon :) |
All times are GMT -4. The time now is 01:42. |