[General] ParaView: Streamline Vectors

FPF · September 13, 2011, 03:35

Hello,

I would like to visualise short streamline vectors in ParaView.

Example:

http://www.komplexsim.de/bilder/four..._massfrac3.png

I searched the documentation but only found the possibility to show continuous streamlines from the inlet to the outlet by using the "stream tracer" filter.

Does anyone have a clue how to manage this?

Greetings
Marc

davide_c · September 13, 2011, 03:41

use the gliph tool, with 2d arrow option and set the last option field ( vector, scalar...) to off. then you can adjust the length of the arrows with the scale factor

FPF · September 13, 2011, 04:27

Thanks a lot. Now it's working! And it's been so close...

davide_c · September 13, 2011, 04:48

you're welcome

the impact with paraview is not as straightforward as it can seem to be...

aguilloux · September 13, 2011, 05:45

Hi,
make a slice before the Glyph filter and you wil have the same result.

September 13, 2011, 03:35	ParaView: Streamline Vectors	#1
FPF New Member Marc Swin Join Date: Sep 2011 Posts: 2 Rep Power: 0	Hello, I would like to visualise short streamline vectors in ParaView. Example: http://www.komplexsim.de/bilder/four..._massfrac3.png I searched the documentation but only found the possibility to show continuous streamlines from the inlet to the outlet by using the "stream tracer" filter. Does anyone have a clue how to manage this? Greetings Marc

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] Streamline Rendering Improvement in Paraview	complexFlow	ParaView	0	October 20, 2017 14:55
How to display the streamline in paraview?	leejearl	SU2	3	November 9, 2014 02:03
[General] Paraview streamline in 2D	Vino	ParaView	2	October 11, 2014 05:16
[OpenFOAM] points over streamline in paraView	cedric_duprat	ParaView	0	January 12, 2010 03:04
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41

September 13, 2011, 03:41		#2
davide_c New Member Davide Cagnoni Join Date: Jul 2011 Posts: 14 Rep Power: 14	use the gliph tool, with 2d arrow option and set the last option field ( vector, scalar...) to off. then you can adjust the length of the arrows with the scale factor

September 13, 2011, 04:27		#3
FPF New Member Marc Swin Join Date: Sep 2011 Posts: 2 Rep Power: 0	Thanks a lot. Now it's working! And it's been so close...

September 13, 2011, 04:48		#4
davide_c New Member Davide Cagnoni Join Date: Jul 2011 Posts: 14 Rep Power: 14	you're welcome the impact with paraview is not as straightforward as it can seem to be...

September 13, 2011, 05:45		#5
aguilloux New Member alexandre Join Date: Sep 2011 Posts: 5 Rep Power: 14	Hi, make a slice before the Glyph filter and you wil have the same result.