|
[Sponsors] |
September 9, 2001, 08:18 |
interphse values
|
#1 |
Guest
Posts: n/a
|
does anyone know what values one should use for PHINT(h1) and PHINT(h2) in two phase liquid-gas system? is it possible to check thermal equilibrium??? how the values for CINT and CFIPS are determined?? your help will be highly appreciated!thank you
|
|
September 10, 2001, 04:53 |
Re: interphse values
|
#2 |
Guest
Posts: n/a
|
Read this lecture on the CHAM website for some basic information on interphase transfer settings:
http://www.cham.co.uk/phoenics/d_pol.../ipsa/ipsa.htm |
|
September 10, 2001, 14:33 |
Re: interphse values
|
#3 |
Guest
Posts: n/a
|
thanx for your reply. i read that page many times, but it does not provide any specific information!?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No rms values for LES | lofty | OpenFOAM Running, Solving & CFD | 18 | December 24, 2018 13:09 |
Ensight - node values -cell values | leo | FLUENT | 1 | May 12, 2010 08:47 |
node values or cell values? | aPpA | FLUENT | 0 | November 10, 2006 08:56 |
3D - How to set Ref. values... ? | Cyril | FLUENT | 0 | June 22, 2006 09:36 |
y+ values | Mark Fahey | CFX | 4 | January 9, 2004 23:05 |