interphse values

September 9, 2001, 08:18

does anyone know what values one should use for PHINT(h1) and PHINT(h2) in two phase liquid-gas system? is it possible to check thermal equilibrium??? how the values for CINT and CFIPS are determined?? your help will be highly appreciated!thank you

September 10, 2001, 04:53

Read this lecture on the CHAM website for some basic information on interphase transfer settings:

http://www.cham.co.uk/phoenics/d_pol.../ipsa/ipsa.htm

September 10, 2001, 14:33

thanx for your reply. i read that page many times, but it does not provide any specific information!?

September 9, 2001, 08:18	interphse values	#1
marko Guest Posts: n/a	does anyone know what values one should use for PHINT(h1) and PHINT(h2) in two phase liquid-gas system? is it possible to check thermal equilibrium??? how the values for CINT and CFIPS are determined?? your help will be highly appreciated!thank you

September 10, 2001, 04:53	Re: interphse values	#2
Mike Malin Guest Posts: n/a	Read this lecture on the CHAM website for some basic information on interphase transfer settings: http://www.cham.co.uk/phoenics/d_pol.../ipsa/ipsa.htm

September 10, 2001, 14:33	Re: interphse values	#3
marko Guest Posts: n/a	thanx for your reply. i read that page many times, but it does not provide any specific information!?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No rms values for LES	lofty	OpenFOAM Running, Solving & CFD	18	December 24, 2018 13:09
Ensight - node values -cell values	leo	FLUENT	1	May 12, 2010 08:47
node values or cell values?	aPpA	FLUENT	0	November 10, 2006 08:56
3D - How to set Ref. values... ?	Cyril	FLUENT	0	June 22, 2006 09:36
y+ values	Mark Fahey	CFX	4	January 9, 2004 23:05