|
[Sponsors] |
March 12, 2002, 03:33 |
the problem of £Ë-¦Å model
|
#1 |
Guest
Posts: n/a
|
If I simulate the solid(density:1500,inlet velocity:2m/s)-water(density:1000,velocity:2m/s) flow in a pipe and at the same temperature, which model is the best? can I apply the £Ë-¦Å model? if so ,should I config it? is the Energy equation necessary in the models?thanks lot .
|
|
March 20, 2002, 08:04 |
Re: the problem of £Ë-¦Å model
|
#2 |
Guest
Posts: n/a
|
I have guessed that you mean the K-E Turbulence model.
I had to guess because we only see very strange characters in your message for the model. My guess is that you entered the Greek letters 'Kappa' and 'Epsailon' at your end, but Internet Explorer has translated these as other characters when it gets to our end. For our version of Internet Explorer, your subject appears as 'Re:the problem of Q model' ,where Q is, in fact, an English pound sign, followed by E, above which are 2 dots, followed by a -, followed by a vertical line, followed by A, above which there is a little circle. If you just use English characters in future, e.g. K-E, or k-e, then the character problem can hopefully be avoided. Assuming you mean the K-E Turbulence model, and that you are modelling solid particles in flowing water in a pipe, then we can point you to some relevant information via the CHAM website, at... http://www.cham.co.uk - Click on the Home Page, then Encyclopaedia, then Turbulence, then Multi phase various, and then Enhancements for Turbulence modulation due to particles. - For some similar Library file examples, except that they are 1-dimensional, click on Home Page, Short cuts, Input-File Library, Option Libraries, Advanced multi-phase, IPSA: one-dimensional validation cases. Then see library files P203, and P204. The paths are... http://www.cham.co.uk/phoenics/d_ear...nplib/p203.htm and http://www.cham.co.uk/phoenics/d_ear...nplib/p204.htm - For a similar Library file example, except that it is air instead of water, and you probably wish to use an elliptic rather than a parabolic model, click on the paths as above, except instead of clicking on IPSA, click on ' Two-Dimensional validation cases'. The path is... http://www.cham.co.uk/phoenics/d_ear...nplib/p219.htm I hope this helps. Regards, Pete. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with VOF model | vuthuan | FLUENT | 4 | September 30, 2008 22:58 |
problem with vof model | nadav wetzler | FLUENT | 1 | February 26, 2008 02:09 |
Problem with DES model | mehul | Phoenics | 0 | April 12, 2006 08:00 |
problem of RSM model | lingo | FLUENT | 1 | June 6, 2004 02:39 |
Model problem? | David | FLUENT | 0 | December 5, 2000 21:53 |