|
[Sponsors] |
August 6, 2002, 06:02 |
how to build the grid
|
#1 |
Guest
Posts: n/a
|
my problem is: the domain structure is a cylinder which is rotated in high speed.
inlet is on one end of the cylinder which is on the axle center. outlet is on the other end of the cylinder but it is not on the axle. inlet & outlet is rotate with the domain cylinder. how to build this grid, how to define the boundary condition. who can help me and give some suggesion. Thanks very much Fan |
|
August 8, 2002, 01:38 |
help me
|
#2 |
Guest
Posts: n/a
|
who can help me
|
|
August 8, 2002, 23:43 |
Vikas Kumar
|
#3 |
Guest
Posts: n/a
|
Vikas Kumar , can you help me
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Circular Pipe grid generation in CFX4.4 Build | KKA | CFX | 2 | December 2, 2003 10:33 |
help in cfx-build 5.6 | FERNANDO VICENTE | CFX | 3 | September 18, 2003 18:28 |
Local grid refinement with CFX-Build 4.2? | Budi D | CFX | 0 | May 31, 2001 08:34 |
Near-wall grid/meshing problems with CFX-Build | Mark | CFX | 1 | December 18, 2000 17:10 |
CFX-Build 4: Butterfly Grid | Anthony Williams | CFX | 0 | October 31, 2000 12:45 |