|
[Sponsors] |
November 18, 2002, 06:09 |
WHAT IS "RUN-TIME ERROR"
|
#1 |
Guest
Posts: n/a
|
When I carry out a simulation with a lot of girds, after sever sweeps, an error will come up says "run-time error". If I reduce the number of grids, it will be OK. Why? Who can told me? Thanks
|
|
November 18, 2002, 21:31 |
Re: WHAT IS "RUN-TIME ERROR"
|
#2 |
Guest
Posts: n/a
|
I have had similar problems with my work.
For me it was based on hard drive space. One of the run time files was very large, in my case in the order of 1 - 2GB. The run would crash and I recieved an run time error. I reduced the number of grids and the system worked - then I purchased an new hard drive. Hope this helps. Leon |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"""Source Term in UDS""" | Sebeci | FLUENT | 6 | April 16, 2003 12:46 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
FLUENTUDF+"TIME" VARIABLE NAME IN COUP+EXP SOLVER? | Taner | FLUENT | 4 | April 16, 2002 04:58 |
"laminar" incomp. N-S eqs. for "turbulent" flows | wowakai | Main CFD Forum | 4 | November 27, 2001 05:48 |
what's the difference between "successive substitution" and "segregated" solutions?? | wai | Main CFD Forum | 1 | December 28, 1998 09:24 |