Home > Forums > Software User Forums > Phoenics

Cyclic boundary condition in Multi-Block.

Mark Forums Read

Reply

Search this Thread

November 9, 2002, 10:39	Cyclic boundary condition in Multi-Block.	#1
Las Guest Posts: n/a	Hi, I am trying to simulate a film cooled turbine blade using PHOENICS 3.3. However, when I used the Multi-block, cyclic boundary condition do not work. Any help would be greatly appreciated. Thank you. Las.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cyclic Boundary Condition	Luiz Eduardo Bittencourt Sampaio (Sampaio)	OpenFOAM Running, Solving & CFD	36	July 2, 2012 12:23
Cyclic jump boundary condition	hjasak	OpenFOAM Running, Solving & CFD	10	April 16, 2010 15:35
Cyclic boundary condition	qtian	OpenFOAM Running, Solving & CFD	3	November 12, 2008 21:23
Cyclic Boundary Condition	SG	Siemens	0	June 1, 2008 14:56
Multi-Block Interface (Patched Boundary)	Park K.W.	Main CFD Forum	2	February 18, 2000 05:46

All times are GMT -4. The time now is 20:17.