|
[Sponsors] |
February 17, 2004, 02:33 |
visibility level vs smoke
|
#1 |
Guest
Posts: n/a
|
I am modelling a fire in a room using FLAIR module. Could anyone please tell me how can I convert a SMOK value into a visibility index (any system is acceptable,ie. visibility within certain distance). For instance, if I set SMOK value of 1.0 at the fire, SMOK values of plume or smoke layer inside the room are less than 1.0. Any information on any website will be greatly appreciated.
|
|
May 21, 2004, 12:39 |
Re: visibility level vs smoke
|
#2 |
Guest
Posts: n/a
|
please, send my directly your question Alexander
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Smoke visibility | André | FLUENT | 5 | December 5, 2020 14:05 |
Smoke Simulation | prashant24983 | OpenFOAM Running, Solving & CFD | 3 | July 1, 2020 13:23 |
Smoke Modelling | Oli | CFX | 1 | August 23, 2007 18:17 |
How to turn off visibility of a plane from command | CFXuser | CFX | 1 | April 4, 2006 09:56 |
Please HELP (Smoke simulation) | Amr | FLUENT | 0 | February 25, 2006 19:38 |