|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello, I'm trying to run 3.6 but i'm getting an "insufficient virtual memory" complaint each time. I've set the F-Array to that specified in the prompt as well as doing this /3GB boot.ini switch, but the same complaint appears at every attempt to run. Can anyone help? Thanks
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
I think that with 3.6 you increase a variable in the file cham.ini. I would try copying this file (from phoenics\d_appro)to my working directory and increasing the Earth setting.
[F-array] Satellite = 2000000 Earth = 10000000 <-- Increase this one !! Photon = 100000 Pinto = 100000 |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Virtual memory problem with parallel runs | Ali (Ali) | OpenFOAM Running, Solving & CFD | 21 | May 25, 2011 04:27 |
Insufficient virtual memory | sammi | Phoenics | 4 | April 8, 2009 13:32 |
High performance virtual memory tip | connclark | OpenFOAM Running, Solving & CFD | 0 | December 5, 2007 18:35 |
Help with virtual memory | tom | Phoenics | 10 | July 19, 2007 14:50 |
Virtual Mass | Podila | CFX | 0 | October 4, 2005 12:30 |