|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I installed 2006 version (3.6.2) on my notebook computer. Everything is working except there is a display problem. In Viwer or Editor, I can not zoom further than certain ratio. The diplayed object simply disappears from the window and it shows up again after zoom out. There was no such problem with previous version. Does anyone has same problem with this new version or is there any solution to it? Thank you in advance.
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi David. I had the same problem. Go to the "Settings" tab and choose "Near Plane". Then set the value of "Near Plane" as minimum as possible. I hope that this tip solve your problem.
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thank you Wellington. It worked.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Phoenics 2006 is possible in 64bit window system? | YSCHO | Phoenics | 1 | July 19, 2007 10:05 |
2006 European PHOENICS User Meeting | Peter Spalding | Phoenics | 0 | August 8, 2006 06:19 |
if fieldview can display phoenics result perfctly | fan jinglng | Phoenics | 2 | October 16, 2002 07:42 |