Display problem with PHOENICS 2006

October 18, 2006, 11:05

I installed 2006 version (3.6.2) on my notebook computer. Everything is working except there is a display problem. In Viwer or Editor, I can not zoom further than certain ratio. The diplayed object simply disappears from the window and it shows up again after zoom out. There was no such problem with previous version. Does anyone has same problem with this new version or is there any solution to it? Thank you in advance.

October 18, 2006, 12:18

Hi David. I had the same problem. Go to the "Settings" tab and choose "Near Plane". Then set the value of "Near Plane" as minimum as possible. I hope that this tip solve your problem.

October 19, 2006, 07:27

Thank you Wellington. It worked.

October 18, 2006, 11:05	Display problem with PHOENICS 2006	#1
David Guest Posts: n/a	I installed 2006 version (3.6.2) on my notebook computer. Everything is working except there is a display problem. In Viwer or Editor, I can not zoom further than certain ratio. The diplayed object simply disappears from the window and it shows up again after zoom out. There was no such problem with previous version. Does anyone has same problem with this new version or is there any solution to it? Thank you in advance.

October 18, 2006, 12:18	Re: Display problem with PHOENICS 2006	#2
Wellington M. Brondani Guest Posts: n/a	Hi David. I had the same problem. Go to the "Settings" tab and choose "Near Plane". Then set the value of "Near Plane" as minimum as possible. I hope that this tip solve your problem.

October 19, 2006, 07:27	Re: Display problem with PHOENICS 2006	#3
David Guest Posts: n/a	Thank you Wellington. It worked.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Phoenics 2006 is possible in 64bit window system?	YSCHO	Phoenics	1	July 19, 2007 10:05
2006 European PHOENICS User Meeting	Peter Spalding	Phoenics	0	August 8, 2006 06:19
if fieldview can display phoenics result perfctly	fan jinglng	Phoenics	2	October 16, 2002 07:42