|
[Sponsors] |
November 30, 2007, 19:39 |
import ppm as boundary condition
|
#1 |
Guest
Posts: n/a
|
can any body write to me how insert ppm of carbonmonoxide as boundary condition in indoor a cabin
|
|
December 1, 2007, 18:58 |
Re: import ppm as boundary condition
|
#2 |
Guest
Posts: n/a
|
I *believe* that if you have different chemical species, you might have to use SCRS or else CHEMKIN in a non-reacting (low temperature) mode. You might also check out the library cases maybe SMOKE models will work, since it's really only a gas-phase diffusion problem you're doing... Patti
|
|
December 1, 2007, 19:35 |
Re: import ppm as boundary condition
|
#3 |
Guest
Posts: n/a
|
patti thank u very much for ur helping .i have only co in air that intake no other chemical species .and only want know distribution of co in interior .thank if response to me
|
|
December 3, 2007, 14:11 |
Re: import ppm as boundary condition
|
#4 |
Guest
Posts: n/a
|
No, if you have ppm of CO input, you MUST also have air or some other diluent (chemical species). So it is a chemistry problem. I don't know what version of Phoenics you're using, but I think I would try something simple such as the smoke model. File/Load From Libraries.../Browse - I haven't used later versions of phoenics in a while, but I think there was a case of a localized fire in a building. You can set the fire parameters (gas output).
CHAM, do you think that's appropriate? Dilute smoke? My intuition is that at atmospheric pressure, turbulent convection is the driver for transport... Patti |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is it possible to import boundary conditions? | Tim | CFX | 4 | April 16, 2008 00:54 |
Boundary condition of the third kind or Danckwertz boundary condition | plage | OpenFOAM Running, Solving & CFD | 4 | October 3, 2006 12:21 |
Pressure change after import init. condition file | Tony | CFX | 0 | October 18, 2004 22:46 |
I-DEAS CAD data import with boundary conditions | Yunus | Siemens | 1 | June 1, 2001 10:04 |
I-DEAS CAD data import with boundary conditions | Yunus | FLUENT | 2 | March 14, 2001 14:45 |