Dear Richard,

Thank you. I am waiting for your reply. I have sent you the q1 file, please check PVT msg.

mukut

Dear Richard,

have you got Q1 file? There are some error and today's I have made correction.

like at North wall the value of EPOT should be XG^2-0.01
I have used two inlet BC but one is ok, I think....because I initialize permittivity in air and dielectric separately....

I don't understand how to apply Prndlt(EPOT)....

another thing is there are some technical fault in Phoenics in our campus, computer center confirmed some error in PLANT coding.....so I can't use any PLANT code in Q1. Now EPOT looks like as follows:

http://i32.tinypic.com/293j57r.png

Thickness of electrode is too small so how can I define such micro scale thickness? or defining the electrode at the south and north wall for upper and lower domain respectively?

I am waiting for your next reply....

Today I have tried several times to open this forum and sometime it opens but during submitting reply, then page load error is occurred :(

Dear Richard,

Where are you? please help me :(

anybody help me please...

I am still crawling.......need some help to go smoothly. Please if you have any suggestion please write here.

Thnx

Please check my thread also.