|
[Sponsors] |
June 3, 2011, 13:56 |
Inlet boundary condition
|
#1 |
New Member
Arnie
Join Date: Jul 2009
Posts: 6
Rep Power: 16 |
I am simulating flow in a duct containing rod bundle. I have simulated till a particular length but still haven't obtained fully developed profiles. Is it possible to use the velocity profile distribution at the exit of the channel for starting the simulation again. It would be like just adding on to the length I have already simulated. Is there any provision for inputing such a boundary condition in PHOENICS, where the inlet flow can be specified by the outlet flow distribution obtained in a previous simulation?
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
How to use a solution as an inlet boundary condition in another problem in fluent | geryes | FLUENT | 0 | February 25, 2010 16:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
inlet and outlet boundary condition for turbomachinery solution | siamak1424 | OpenFOAM | 2 | August 15, 2009 11:14 |
Natural convection - Inlet boundary condition | max91 | CFX | 1 | July 29, 2008 20:28 |