|
[Sponsors] |
May 11, 2014, 02:19 |
Extrude normal problem
|
#1 |
New Member
Jack B.
Join Date: Apr 2009
Posts: 24
Rep Power: 17 |
Hi,
I'm trying to extrude normal hyperbolic mesh from semi-cylinder with hemispherical cap (with a pole at it's end). At the beginning the extrusion was fine but after some attempts (which also included an increment of the grid points in the pole) the hyperbolic extusion failes in the pole area. 1. what is the required BC for the pole? is it the same as the other curves? (e.g. Symmetry Z) 2. is there any limitation for the number of grid points at the pole? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Normal vector, slope and aspect angle | g_niro | Main CFD Forum | 0 | February 2, 2011 17:24 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 04:26 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
How to extrude 2D Mesh in ICEM CFD? | VSB | CFX | 7 | December 27, 2006 11:58 |