|
[Sponsors] |
August 4, 2014, 03:56 |
Can I move a node manually?
|
#1 |
Senior Member
Sangwoo Kim
Join Date: Jul 2014
Location: Seoul, South Korea
Posts: 115
Rep Power: 11 |
Hi all
Is there a function to move a node manually in Pointwise? Others are good, but only one cell is bothering me I want to move a node so that the skewness of the cell decreases. So far, I used to make a connector of 2 dimensions near the node that I'm considering, but it's too complex and inconvenient Thanks in advance!
__________________
Best regards |
|
August 4, 2014, 10:47 |
|
#2 |
Senior Member
Travis Carrigan
Join Date: Jul 2010
Location: Arlington, TX
Posts: 161
Rep Power: 15 |
Hello Sangwoo,
You can use the tweak command. You'll find it under the Edit menu in Pointwise. This command will allow you to move individual nodes on the interior of a mesh. See image. tweak.jpg Travis |
|
August 4, 2014, 21:01 |
|
#3 |
Senior Member
Sangwoo Kim
Join Date: Jul 2014
Location: Seoul, South Korea
Posts: 115
Rep Power: 11 |
omg
This is exactly what I'm looking for!! Thanks a lot!
__________________
Best regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
mpirun, best parameters | pablodecastillo | Hardware | 18 | November 10, 2016 12:36 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
999999 (../../src/mpsystem.c@1123):mpt_read: failed:errno = 11 | UDS_rambler | FLUENT | 2 | November 22, 2011 09:46 |