CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Mesh Generation & Pre-Processing Software > Pointwise & Gridgen

How to make a good layer grid for WingStore case by T-Rex

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   January 29, 2016, 02:14
Default How to make a good layer grid for WingStore case
  #1
New Member
 
ZhengJJ
Join Date: Mar 2011
Posts: 7
Rep Power: 15
fengyunmanbu is on a distinguished road
Hello, everybody.
When I use T-Rex to make a layer grid for Wing Store case(the case in tutorials file), it's difficult to make a good quality grid for NS simulation. Anyway, I output the grid and combine an-isotropic tetrahedra.

Then I input the grid into the Fluent, but the mesh quality check warning that "Minimum Orthogonal Quality = 5.14e-3, Waring: minimum Orthogonal Quality below 0.01". The quality can't be improved via the TUI command such as "improve-quality".

So how can I to make a better layer grid in Pointwise, the T-Rex is suitable to make layer grid? or what's the knack to make a high-guality T-Rex grid?

Thanks in advance
Attached Images
File Type: jpg gridInPointwise.jpg (209.4 KB, 24 views)
File Type: jpg outputGird.jpg (218.1 KB, 16 views)
File Type: png checkInFluent.png (4.2 KB, 11 views)

Last edited by fengyunmanbu; January 30, 2016 at 01:12.
fengyunmanbu is offline   Reply With Quote

Reply

Tags
layer grid, t-rex, wingstore

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[snappyHexMesh] snappyHexMesh Boundary Layer at Corner panpanzhong OpenFOAM Meshing & Mesh Conversion 5 July 3, 2018 05:53
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case sharonyue OpenFOAM Meshing & Mesh Conversion 1 April 22, 2013 23:34
[snappyHexMesh] snappy hangs while layer generation bastil OpenFOAM Meshing & Mesh Conversion 3 October 29, 2010 07:19
OpenFOAM with IBM AIX matthias OpenFOAM Installation 20 March 25, 2008 02:36
Grid Independent Solution Chuck Leakeas Main CFD Forum 2 May 26, 2000 11:18


All times are GMT -4. The time now is 18:42.