Interface boundary conditions Pointwise
 

Hi folks,
I'm meshing with Pointwise a complex geometry with several interface domains. I want to expot it to Fluent. I did 2 blocks,one fluid and one solid, and in the boundary conditions i've selected all connects with the same side and i've put them in a condition(interface). I've done the same things for the other side. In this way i want create a coupled wall in Fluent settings.I've set the volume conditions too. Is this the right way to do this?.
The side are correct or should be checked one by one?.
Thanks

That sounds like it should work, but I believe the BC type you want is wall. You can set that directly in Pointwise or change it when you get to Fluent.

Rick

Thanks for your responses.