|
[Sponsors] |
May 4, 2020, 21:40 |
Meshing a cylinder in Pointwise
|
#1 |
New Member
Join Date: Feb 2017
Posts: 6
Rep Power: 9 |
I am trying to mesh a cylinder in Pointwise. I am beginning by meshing the two end caps (I need the mesh in the inner cylinder, not the annulus (pic attached)). However, Create -> Assemble Special -> Domains does not work and I am unable to generate the surface mesh.
I am not sure if there is something I am doing incorrectly: I have generated connectors and nodes on all the required lines. Any help would be gratefully appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] 3D Free surface flow past circular cylinder meshing using GMSH | arieljeds | OpenFOAM Meshing & Mesh Conversion | 7 | January 14, 2017 12:57 |
Meshing inclined cylinder with PBC tetra mesh ICEM | shashi_soman | Mesh Generation & Pre-Processing | 1 | September 26, 2015 18:05 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Meshing spheres in a cylinder | Jesse | FLUENT | 3 | November 23, 2005 21:03 |