|
Boundary conditions, starccm+ simulation
5 Attachment(s)
Hello,
I have created a block by extrusion in pointwise and have set the following part as inlet and outlet. I want to know if it's correct or not?Attachment 77646 Attachment 77647Attachment 77648 Is there any way I can create smooth mesh like this but in rectangular shape? My JOB was to import this volume mesh in starccm+. As you can from the residual, there is some flaws like turbulent viscosity going on. Attachment 77649Attachment 77650 Is there anyway I can improve this mesh to simulate it in starccm+? I have tried rectangular block manually, but the simulation does not run after 272 iterations! |
| All times are GMT -4. The time now is 00:38. |