|
[Sponsors] |
May 15, 2020, 02:01 |
Boundary conditions, starccm+ simulation
|
#1 |
Member
Marium Mou
Join Date: Mar 2020
Posts: 30
Rep Power: 6 |
Hello,
I have created a block by extrusion in pointwise and have set the following part as inlet and outlet. I want to know if it's correct or not?Capture.PNG inlet.PNGoutlet.PNG Is there any way I can create smooth mesh like this but in rectangular shape? My JOB was to import this volume mesh in starccm+. As you can from the residual, there is some flaws like turbulent viscosity going on. waves.PNGres.jpg Is there anyway I can improve this mesh to simulate it in starccm+? I have tried rectangular block manually, but the simulation does not run after 272 iterations! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
CFD analaysis of Pelton turbine | amodpanthee | CFX | 31 | April 19, 2018 18:02 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |