Home > Forums > Mesh Generation & Pre-Processing Software > Pointwise & Gridgen

Pointwise Join Connectors Problem

Mark Forums Read

Reply

Search this Thread

May 26, 2024, 16:04	Pointwise Join Connectors Problem	#1
fqy New Member Join Date: Jan 2022 Posts: 3 Rep Power: 5	Hi, Pointwise V18.6 R2 shows "Info: None of the 15 connectors could be joined. Info: At least one node shared with more than 2 connectors: 15 connectors. Info: Copied 15 connectors." when I try to link connectors at the root of the propeller. Any thoughts? https://cloud.tsinghua.edu.cn/f/935e...4d8b8c36/?dl=1

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Problem when using Pointwise grid with OpenFOAM	quarkz	OpenFOAM Meshing & Mesh Conversion	8	July 30, 2021 02:57
Problem found in Pointwise - Fluent	Joke	Pointwise & Gridgen	5	September 22, 2013 06:23
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13

All times are GMT -4. The time now is 21:06.