Cannot set boundary conditions in Poitwise -- CFD Online Discussion Forums

November 10, 2010, 05:20	Cannot set boundary conditions in Poitwise	#1
filipwa New Member Filip Wallberg Join Date: Oct 2010 Posts: 23 Rep Power: 15	I am trying to learn how to use Pointwise for 3D meshing and I have encountered some problems when it comes to selecting boundary conditions. The mesh I am playing with at the moment is the PipeInACube which is one of the tutorials that come with the software. When selecting BC, I would like to give the pipe inside the cube a wall condition. However, selecting those two domains that make up the pipe is impossible... And looking in "List, Domains" those two domains are also greyed out... Why is this? And how should I go about setting BC for these two domains? Thanks!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Boundary conditions for simpleSRFFoam	cnsidero	OpenFOAM Running, Solving & CFD	5	May 17, 2017 11:26
[Netgen] boundary conditions and mesh exporting	vaina74	OpenFOAM Meshing & Mesh Conversion	2	May 27, 2010 09:38
How to set the changeable boundary conditions.	raintung	FLUENT	3	December 14, 2004 06:48

All times are GMT -4. The time now is 07:32.