problem in maximum scour depth
2 Attachment(s)
Dear REEF3D team and other forum friends.
When I am doing a monopile simulation under pure wave, I found this phenomenon: the maximum scour depth shown in paraview post-processing does not match with the one shown in REEF3D_sedimentlog, and at some times, the difference between them can be up to double, may I know what causes the mismatch between them? What value should I base on? |
Looks plausible. The log is exact. The round-off error occur due to the interpolation and contouring in ParaView.
|
Quote:
|
not really. Is there a need? The difference is very small.
|
Quote:
|
Just take the console print out as well as the sediment bed gages, they are accurate.
|
Can you please share the input control and ctrl files i am not to visualise scour around a monopile. I started using REEF3D recently and it's a steep learning curve can you please help me.
|
All times are GMT -4. The time now is 07:23. |